A. yes
B. no
C. sometimes
D. rarely
E. very often

Advertisement

Related Mcqs:

  1. The shearing stresses in the inner face as compared to outer face of the wire in a heavy close coiled spring is_________________?
    A. larger B. smaller C. equal D. larger/smaller depending on diameter of spring coil E. unpredictable...
  2. When a close coiled helical spring is compressed, its wire is subjected to________________?
    A. tension B. shear C. compression D. all of the above E. none of the above...
  3. The property of a material which enables it to resist fracture due to high impact loads is known as__________________?
    A. elasticity B. endurance C. strength D. toughness E. resilience...
  4. If a material fails below its yield point, failure would be due to___________________?
    A. straining B. fatigue C. creep D. sudden loading E. impact loading...
  5. Yield point in fatigue loading as compared to static loading is__________________?
    A. same B. higher C. lower D. depends on other factors E. none of the above...
  6. A stud________________________?
    A. has a head on one end and a nut fitted to the other B. has head at one end and other end fits into a tapped hole in the other part to be joined C. has both the ends threaded D. has pointed threads E. requires locking nuts...
  7. Transverse fillet welded joints are designed for________________?
    A. tensile strength B. compressive strength C. shear strength D. bending strength E. torsional strength...
  8. The strap end of a connecting rod of steam engine is joined by_________________?
    A. gib of cotter joint B. sleeve and cotter joint C. spigot socket cotter joint D. knuckle joint E. universal coupling...
  9. Allen bolts are___________________?
    A. self locking bolts B. designed for shock load C. used in aircraft application D. provided with hexagonal depression in head E. uniform strength bolts...
  10. Elastic nut is a locking device in which__________________?
    A. one small nut is tightened over main nut and main nut tightened against smaller one by loosening, creating friction jamming B. a slot is cut partly in middle of nut and then slot reduced by tightening a screw C. hard fiber or nylon cotter is recessed in the nut and becomes threaded as the...
Advertisement